Here are some fabulous ring clamp modifications from
@mountain_creek_designs - “I used a coarse drum in the dremel to sand out a route wide enough to fit my ring clamp against my bench pin. To hold spinner rings so I can sand and polish the inside I used the coarse sanding drum again and an abrasive grinding wheel to make a half round area on each side, so when squeezed together they hold a ring perfectly.” This tip goes perfectly with the bench pin modifications from
@alexboydstudio a few weeks ago 💕 thank you so much for sharing with us! 🙌
#metalsmithsociety #jewelrytoolmodification odification
#jewelrytools #makingjewelry
