Sharing the process of pierce sawing from
@mcoledesignz - “Here’s a quick recap of what I did on & off camera after drawing & printing 2 slightly different design templates. I chose the 9 wave design over the 8. • Cut designs to fit inside bezels (not shown) • Adhered with rubber cement • Tamped down with eraser pen • Set drill hole with center punch (not shown) • Drilled start hole for piercing • Pierced with
@greenlionsawframe • Used
@riogrande 5/0 Laser Gold blade • Lubed with
@pepetools_usa Blade Butter • Refined edges with #4 needle files (not shown) • Smoothed edges with 2mm Pin Polisher” We 👏 appreciate 👏 your 👏 share! I love this communities process videos. There are so many helpful tips within this one video for folks that are beginning their jewelry making journey or perhaps were shown a different way. Thank you again!
#sawingmetal #makingjewelry #jewelrymakingprocess #jewelrymakingtips #jewelrytips #jewelrytipsrepost
